View source for 8020Endurance:Installation:SetupWatch

{{DISPLAYTITLE:Introduction}}

After installation of the datafield with GARMIN Connect you can add the datafield to your prefered activity. There are different ways to do this, here is how I usually do on my FENIX 5 Plus...<br /> 
<br /> 


{| cellspacing="20"
|-
|[[Image:Install_1.JPG|x200px]]
|[[Image:Install_2.JPG|x200px]]
|}
Start the activity (here running) by pressing ''Enter''<br /> 
<br /> 

Push ''Up'' (or hold ''Up'' to open options and choose "Run Settings"<br /> 
<br /> 

From there choose "Data Screens" and scroll ''Down'' to "Add" a new screen (or edit an already existing screen if you like)<br /> 
<br /> 

Now choose "Custom Data" for a custom layout then select 1, 2, 3 data fields how many as you need.<br /> 
<br /> 

Please note that the 80/20 Zones displays will look different depending on the screen size. Using full screen (1 datafield) will give you a lot of information. If you don't need that information or like to add other data that is crucial for your training you can add more field. In this case the information of my 80/20 datafield wil lbe reduced. When using a lot of datafields (3 or more) usually you will only see the label of the current training zone you're in at the moment. (Note that this will have no effect on the data that is recorded in the background. Of course you will see all the training data on the Connect plattform later.)<br /> 
<br /> 

Now choose the content for each field (select field with ''Up''/''Down'' and ''Enter''). Choose "ConnectIQ" fields as this is what my 80/20 data fields actually are.<br /> 
<br /> 

Note that most devices are limited to show a given number of "ConnectIQ" fields. Here in the example the FENIX 5 Plus can only use two ConnectIQ data fields in one activity. You can install as many datafields as you like on the watch but only you can use 2 of them for each activity.<br /> 
<br /> 


Finally choose the data field you like to show. I use the 80/20 Run Zones datafield here. And there it is. Now close the screen editor by pushing ''Back'' several times and start your run...<br /> 
<br />